Kia Forte: ESC Control Module Installation

Second generation YD (2014-2018) / Kia Forte TD 2014-2018 Service Manual / Brake System / ESC(Electronic Stability Control) System / ESC Control Module Installation

1.	Install in the reverse order of removal.

2.	Tighten the HECU mounting bolts and nuts to the specified torque.

3.	After installation, bleed the brake system. (Refer to ESC bleeding of ESC system)

ESC Control Module Removal

1. Turn the ignition switch OFF. 2. Pull up the lock of the HECU connector (A) , then disconnect the connector. ...

Front Wheel Speed Sensor Components

1. Front wheel speed sensor 2. Front wheel speed sensor connector ...

See also:

Cooling Fan Inspection
Fan Motor 1. Disconnect the fan motor connector from the resistor. 2. Connect the battery voltage to the "+" terminal and ...

Shift Lever Installation
1. Install in the reverse order of removal. Install the cable after placi ...

Power Mosfet Replacement
1. Disconnect the negative (-) battery terminal. 2. Disconnect the power mosfet connector (A) and then remove the power mosfet (B) after lo ...

Categories

Copyright © www.kifomanual.com 2014-2026