Kia Forte: Evaporator Temperature Sensor Replacement
Second generation YD (2014-2018) / Kia Forte TD 2014-2018 Service Manual / Heating,Ventilation, Air Conditioning / Air Conditioning System / Evaporator Temperature Sensor Replacement
| 1. |
Disconnect the negative (-) battery terminal.
|
| 2. |
Disconnect the evaporator temperature sensor connector (A).
|
| 3. |
Remove the evaporator temperature sensor (B) by pulling it out
after rotating it 90° in a counterclockwise direction.
|
| 4. |
Install in the reverse order of removal.
|
Evaporator Temperature Sensor Inspection
1.
Turn the ignition switch OFF.
2.
Disconnect evaporator temperature sensor.
3.
Using the multi-tester, measur ...
In-car Sensor (DATC only) Description
An in-car air temperature sensor is located in the crash pad lower panel.
The sensor contains a thermistor which measures the temperature of the
inside. The signal decided by the resistance ...
See also:
Rear Bumper Beam Assembly Component Location
(4Door, 2Door)
1. Rear bumper beam assembly
(5Door)
1. Rear bumper beam assembly
...
Inspection
1.
Inspect diaphragm spring wear which is in contact with a clutch
release bearing.
2.
Check the clutch cover and disc surface for wear or ...
Inspection
Lighting Switch Inspection
With the multifunction switch in each position, make sure that continuity
exists between the terminals below. If continuity is not as specified, replace
the mul ...
Copyright © www.kifomanual.com 2014-2024