Kia Forte: Replacement - Rear Disc Brake - Brake System - Brake System - Kia Forte TD 2014-2018 Service ManualKia Forte: Replacement

Second generation YD (2014-2018) / Kia Forte TD 2014-2018 Service Manual / Brake System / Brake System / Rear Disc Brake / Replacement

Rear Brake Pads
1.
Remove the rear wheel & tire.

Tightening torque:
88.3 ~ 107.9 N.m (9.0 ~ 11.0 kgf.m, 65.1 ~ 79.6 lb-ft)

2.
Release the parking brake lever and parking brake cable is loose.
3.
Loosen the guide rod bolt (B) and then remove the rear caliper body (C).

  
Where necessary prevent the guide rods from rotating with an appropriate wrench.
Be careful not to damage the dust covers.
4.
Replace pad retainers (C) and brake pads (B) in the caliper carrier (A).

  
Clean the pad retainer surface at the caliper bracket.
Inspect the piston boots for damage and replace if necessary.
Check the smooth action of the guide rods, and their dust covers for damage.
5.
Rotate the caliper piston and push the direction of the arrow.

6.
Place the caliper body (C) on the caliper carrier and tighten the guide rod bolts (B).

Tightening torque:
21.6 ~ 31.4 N.m (2.2 ~ 3.2 kgf.m, 15.9 ~ 23.1 lb-ft)

  
Assemble the caliper body so that the piston groove (A) is in-line with the pad center lobe (B).

* Make sure that the piston and pad are tightly attached.
7.
Install the rear wheel & tire.

Tightening torque:
88.3 ~ 107.9 N.m (9.0 ~ 11.0 kgf.m, 65.1 ~ 79.6 lb-ft)

Removal
1. Remove the rear wheel & tire. Tightening torque: 88.3 ~ 107.9 N.m (9.0 ~ 11.0 kgf.m, 65.1 ~ 79.6 lb-ft) ...

Inspection
Rear Brake Disc Thickness Check 1. Check the brake pads for wear and fade. 2. Check the brake disc for damage and cracks. ...

See also:

Fuel Tank Air Filter Installation
   • Install the component with the specified torques. • ...

Ignition Coil Installation
1. Install in the reverse order of removal. Ignition coil installation bolts: 9.8 ~ 11.8 N.m (1.0 ~ 1.2 kgf.m, 7.2 ~ 8.7 Ib-ft) ...

Emergency while driving
In an emergency situation while the vehicle is in motion, you are able to turn the engine off and to the ACC position by pressing the ENGINE START/STOP button for more than 2 seconds or 3 times succ ...

Copyright © www.kifomanual.com 2014-2024