Kia Optima Manuals

Kia Forte: Parking Brake Adjustment - Rear Disc Brake - Brake System - Brake System - Kia Forte TD 2014-2018 Service ManualKia Forte: Parking Brake Adjustment

Second generation YD (2014-2018) / Kia Forte TD 2014-2018 Service Manual / Brake System / Brake System / Rear Disc Brake / Parking Brake Adjustment

  
•
Re-setting of the parking brake is necessary after overhauling the caliper body, or if the brake calipers, housing, parking brake cable or brake discs have been changed.
1.
Remove the floor console to reach the adjusting nut.
2.
Loosen the parking brake cable until both operating levers rest in fully off position.
3.
Bring the brake pads in their operating position by pressing the brake pedal down several times until there is resistance.
4.
Tension the parking brake cable by tightening the adjusting nut, until the operating levers on both calipers lift from the stop, up to a distance of (A) and (D) between operating lever (B) and stopper (C).
Distance (A+D): Max. 3 mm (0.12 in)

5.
Refit the floor console.
6.
Parking brake lever in the car must be in fully loosened position.
7.
If the handbrake cables where changed, actuate the parking brake a few times with maximum force to stretch the parking brake cables, and then control adjusting as above.
8.
Check the wheels of their free operation.
9.
Test drive.
Installation
1. Install in the reverse order of removal. 2. Rotate the caliper piston and push the direction of the arrow. 3. ...

Rear Drum Brake
Components 1. Shoe hold down pin 2. Shoe adjuster 3. Upper return spring 4. Adjusting lever 5. Shoe 6. Adjusting spring 7. Lower return spring 8. Shoe hold spri ...

See also:

Using the usb device
To use an external USB device, make sure the device is not connected when starting up the vehicle. Connect the device after starting up. If you start the engine when the USB device is connected ...

Manifold Absolute Pressure Sensor (MAPS) Description
Manifold Absolute Pressure Sensor (MAPS) is a speed-density type sensor and is installed on the surge tank. It senses absolute pressure of the surge tank and transfers the analog signal propo ...

Front Seat Belt Buckle  Replacement
1. Remove the front seat assembly. (Refer to Front Seat - "Front Seat Assembly") 2. Disconnect the front seat belt buckle conn ...

Categories

Copyright www.kifomanual.com 2014-2026