Kia Forte: Measurement Method

Second generation YD (2014-2018) / Kia Forte TD 2014-2018 Service Manual / Body (Interior and Exterior) / Body Dimensions / Measurement Method

Projected Dimensions

1.	These are the dimensions measured when the measurement points are projected into the reference plane, and are the reference dimensions used for body alterations.

2.	If the length of the tracking gauge probes is adjustable, make the measurement by lengthening one probe by the amount equivalent to the difference in height of the two surfaces.

Actual-Measurement Dimensions

1.	These dimensions indicate the actual linear distance between measurement points, and are the reference dimensions for use if a tracking gauge is used for measurement.

2.

Measure by first adjusting both probes to the same length (A=A').

Check the probes and gauge itself to make sure there is no free play.

Measurement Point

1.	Measurements should be taken at the hole center.

General

1. Basically, all measurements in this manual are taken with a tracking gauge. 2. When a measuring tape is used, check to be sure there is ...

2Door

...

See also:

Fluid Replacement
ATF of the 6-speed automatic transaxle does not need to be replaced for Normal Usage. If the vehicle is used for any of ...

Inhibitor Switch Specifications
▷ Type: Combination of output signals from 4 terminals Power supply (V) 12 Output type Combination of output signals Signal Code Table ...

Front Fog Lamps Inspection
1. Disconnect the negative(-) battery terminal. 2. Remove the lighting switch of the multi-function switch. (Refer to Multifunction Swit ...

Categories

Copyright © www.kifomanual.com 2014-2026