1. |
Basically, all measurements in this manual are taken with a tracking
gauge.
|
2. |
When a measuring tape is used, check to be sure there is no elongation,
twisting or bending.
|
3. |
For measuring dimensions, both projected dimension and actual-measurement
dimension are used in this manual.
|
Timing Chain Cover Removal
Engine removal is not required for this procedure.
•
Use fender covers to avoid damaging pa ...
Front Driveshaft Replacement
1.
Loosen the wheel nuts slightly.
Raise the vehicle, and make sure it is securely supported.
2.
Remove the front wheel and tire (A ...
Center Pillar Trim Replacement
[Center pillar lower trim]
(4Door, 5Door)
•
Put on gloves to protect your hand ...