Kia Forte: Front Body
Front Body A
| * These dimensions indicated in this figure are
actual-measurement dimensions. [ Unit : mm (inch) ] |
Front Body B
| * These dimensions indicated in this figure are
actual-measurement dimensions. [ Unit : mm (inch) ] |
Front Body C
| * These dimensions indicated in this figure are
actual-measurement dimensions. [ Unit : mm (inch) ] |
Front Body D
| * These dimensions indicated in this figure are
actual-measurement dimensions. [ Unit : mm (inch) ] |
|
|
|
|
| Hood hinge mounting hole (Ø10) |
Fender apron upper member corner |
Front shock absorber mounting hole (Ø13) |
|
|
|
|
| Side outer panel front corner |
Side outer panel front corner |
Engine mounting bracket hole (Ø11) |
|
|
|
|
| Transaxle mounting hole (Ø12) |
Engine mounting bracket hole (Ø15) |
Transaxle mounting hole (Ø13) |
|
|
|
|
| Front side member tooling hole (Ø6.6) |
Front side member tooling hole (Ø6.6) |
Front end module mounting hole (Ø11.5) |
4Door
...
Side Body
* These dimensions indicated in this figure are
actual-measurement dimensions. [ Unit : mm (inch) ]
Front side m ...
See also:
Valve Body Installation
1.
Install in the reverse order of removal.
After replacement or reinstallation procedure of ...
Telemetics Unit (TMU) Component
Connector Pin Specification
No.
Pin Name
Type
From
To
Description (Wiring
Spec.)
1
GND
DC Ground
TMU
Batt ...
On-board Refueling Vapor Recovery (ORVR) valve Removal
1.
Turn the ignition switch OFF, and then remove battery (-) cable.
2.
Remove the fuel pump.
(Refer to Fuel System - "Fuel Pump&qu ...