Kia Forte: Under Body
| Projected Dimensions |
| * These dimensions indicated in this figure are
actual-measurement dimensions. [ Unit : mm (inch) ] |
| Actual-Measurement Dimensions |
| * These dimensions indicated in this figure are
actual-measurement dimensions. [ Unit : mm (inch) ] |
|
|
|
|
| Front side member tooling hole (Ø25) |
Side cover mounting hole (Ø8.6) |
Side cover mounting hole (Ø10.7) |
|
|
|
|
| Sub frame mounting bolt |
Sub frame mounting hole (Ø11) |
Center floor tooling hole (Ø8) |
|
|
|
|
| Front side member tooling hole (Ø13) |
Center floor side member tooling hole
(Ø7) |
Rear floor side member tooling hole (Ø10) |
|
|
|
|
| Rear floor side member tooling hole (Ø10) |
Rear floor side member tooling hole (Ø10) |
Rear floor center cross member tooling hole (Ø10) |
|
|
|
|
| Rear floor center cross member tooling hole (Ø10) |
Rear spring mounting hole (Ø9) |
Rear floor side member tooling hole (Ø8) |
|
|
||
| Rear floor side member tooling hole (Ø8) |
Rear Body
* These dimensions indicated in this figure are
actual-measurement dimensions. [ Unit : mm (inch) ]
Side outer p ...
Front Cross Member
* These dimensions indicated in this figure are
actual-measurement dimensions. [ Unit : mm (inch) ]
...
See also:
Variant coding
After replacing the SRSCM with a new unit, the “Variant Coding” procedure
must be performed.
1.
...
Windshield Wiper-Washer Switch Installation
1.
Install the multifunction switch.
2.
Install the clock spring.
3.
Install the steering column upper and lowe ...
Front Door Inside Handle Replacement
(4Door, 5Door, 2Door)
1.
Remove the front door trim.
(Refer to Front Door - "Front Door Trim")
2.
After loosenin ...
Copyright © www.kifomanual.com 2014-2025