Kia Optima Manuals

Kia Forte: Cluster Fascia Panel Replacement - Crash Pad - Body (Interior and Exterior) - Kia Forte TD 2014-2018 Service ManualKia Forte: Cluster Fascia Panel Replacement

Second generation YD (2014-2018) / Kia Forte TD 2014-2018 Service Manual / Body (Interior and Exterior) / Crash Pad / Cluster Fascia Panel Replacement

  
•
Put on gloves to protect your hands.
  
•
When prying with a flat-tip screwdriver, wrap it with protective tape, and apply protective tape around the related parts, to prevent damage.
•
Use a plastic panel removal tool to remove interior trim pieces to protect from marring the surface.
•
Take care not to bend or scratch the trim and panels.
1.
Using a screwdriver or remover, remove the center garnish [LH] (A).
2.
Using a screwdriver or remover, remove the cluster fascia panel (A).
3.
Disconnect the start/stop button connector (A).
4.
Install in the reverse order of removal.
  
•
Make sure the connector are connected in properly.
•
Replace any damaged clips.
Cluster Fascia Panel Component Location
1. Cluster fascia panel ...

Center Fascia Panel Component Location
1. Center fascia panel ...

See also:

Side air bag
Your vehicle is equipped with a side air bag in each front seat. The purpose of the air bag is to provide the vehicle's driver and/or the front passenger with additional protection than that ...

Turn Signal Lamp
Removal 1. Remove the outside rear view mirror. (Refer to Body - "Outside Rear View Mirror") Installation 1. Install the out ...

Component Location
Component Location (1) 1. Smart key unit 2. External buzzer 3. Door outside handle 4. Interior antenna 5. RF receiver Component Location (2) 1. Bump ...

Categories

Copyright www.kifomanual.com 2014-2026