Kia Forte: Front Seat Assembly Replacement

Second generation YD (2014-2018) / Kia Forte TD 2014-2018 Service Manual / Body (Interior and Exterior) / Front Seat / Front Seat Assembly Replacement

•	When removing or installing the front passenger seat, be sure to initialize the Weight Classification System(WCS) (If initialization process is not performed, WCS may not be able to detect a person correctly.) (Refer to Restraint - "Weight Classification System (WCS)")

•	When replacing the WCS, be sure to check the parts unit.

-	Parts unit of WCS : seat track assembly

1.	Remove the front seat track mounting cover.

2.

After loosening the mounting bolts, remove the front seat assembly (A).

Tightening torque :

34.3 ~ 53.9N.m (3.5 ~ 5.5kgf.m, 25.3 ~ 39.8lb-ft)

3.	Disconnect the seat buckle connector (A), seat warmer & power seat connector (B), SAB connector(C), PODS connector (D). [Driver's] [Passenger's]

4.

Install in the reverse order of removal.

•	SEAT MOUNTING BOLT INSTALLATION PROCEDURE

•	Set the seat into the most rearward position. Check that each slide is locked, and then tighten the front mounting bolt temporarily.

•	Set the seat into most forward position. Check that each slide is locked, and then Tighten the rear mounting bolt completely.

•	Set the seat into the most rearward position. Check the front mounting bolt completely.

•	Check that the seat operates to and fro smoothy and the locking portion locks properly.

Front Seat Assembly Component Location

1. Front seat assembly ...

Front Seat Shield Outer Cover Component Location

1. Front seat shield outer cover ...

See also:

CVVT Oil Control Valve (OCV) Installation
• Install the component with the specified torques. • ...

Using the iPod® device
Some iPod® models may not support communication protocol and files may not properly play. Supported iPod® models: iPhone® 3GS/4 iPod® touch 1st~4th generation iPod® nano 1st~6th generation ...

A/C Pressure Transducer Inspection
1. Measure the pressure of high pressure line by measuring voltage output between NO.1 and NO.2 terminals. 2. Inspect the voltage v ...

Categories

Copyright � www.kifomanual.com 2014-2026