Kia Forte: Inspection

Second generation YD (2014-2018) / Kia Forte TD 2014-2018 Service Manual / Body Electrical System / Keyless Entry And Burglar Alarm / Inspection

Front Door Lock Module Inspection

1.	Remove the front door trim. (Refer to Body - "Front Door Trim")

2.	Remove the front door module. (Refer to Body - "Front Door Module")

3.	Disconnect the connector from the actuator.

4.	Check actuator operation by connecting power and ground according to the table. To prevent damage to the actuator, apply battery voltage only momentarily.

Rear Door Lock Module Inspection

1.	Remove the rear door trim. (Refer to Body - "Rear Door Trim")

2.	Remove the rear door module. (Refer to Body - "Rear Door Module")

3.	Disconnect the connector from the actuator.

4.	Check actuator operation by connecting power and ground according to the table. To prevent damage to the actuator, apply battery voltage only momentarily.

Trunk Lid / Tailgate Release Module Inspection

[2/4 Door]

1.	Remove the trunk lid trim. (Refer to Body - "Trunk Lid Trim")

2.	Disconnect the connector from the actuator. [2 Door] [4 Door]

3.	Check actuator operation by connecting power and ground according to the table. To prevent damage to the actuator, apply battery voltage only momentarily.

[5 Door]

1.	Remove the tailgate trim. (Refer to Body - "Tailgate Trim")

2.	Disconnect the connector from the actuator.

3.	Check actuator operation by connecting power and ground according to the table. To prevent damage to the actuator, apply battery voltage only momentarily.

Door Switch Inspection

Remove the door switch and check for continuity between the terminals.

Hood Switch Inspection

1.	Disconnect the connector from the hood switch (A).

2.	Check for continuity between the terminals and ground according to the table.

Burglar Horn Inspection

1.	Remove the burglar horn (A) after removing a nut and disconnect the connector (B) from the burglar horn.

2.	Test the burglar horn by connecting battery power to the terminal 1 and ground the terminal 2.

3.	The burglar horn should make a sound. If the burglar horn fails to make a sound replace it.

Description

Burglar Alarm State [B/A State] B/A State Description DISARM 1. In "DISARM" state, no vehicle start inhibition. So, whe ...

Transmitter Inspection

1. Check that the red light flickers when the door lock or unlock button is pressed on the transmitter. 2. Remove the battery (A) and check ...

See also:

Seat Heater Switch Installation
Driver/Passenger Seat 1. Install the switchs and connect the switch connectors. 2. Insatll the floor console assembly. ...

Fuel Pressure Regulator Installation
1. Install in the reverse order of removal. ...

AGM Battery Inspection
Battery Diagnostic Flow Vehicle parasitic current inspection 1. Turn all the electric devices OFF, and then turn the ignition switch OFF. ...

Categories

Copyright � www.kifomanual.com 2014-2026