Kia Forte: IMS module Installation

Second generation YD (2014-2018) / Kia Forte TD 2014-2018 Service Manual / Body Electrical System / IMS (Integrated Memory) / IMS module Installation

1.	Install the IMS module after connecting the connector.

2.

Install the front seat.

-	Make sure the IMS module connectors and related connectors are plugged in properly.

-	Check that IMS system operates normally.

IMS module Removal

1. Remove the negative (-) battery terminal. 2. Remove the driver seat in the car. (Refer to Body - "Front Seat Assembly") ...

IMS Power Seat Control Circuit diagram

...

See also:

Room lamp
To turn the room lamp ON or OFF, push the switch. If your vehicle is not equipped with a map lamp, the room lamp will also turn on or off as follows. The room lamp comes on when a door is opene ...

TPMS Sensor
1. Storage State Sensors are in this state when they first arrive at dealership. This state is entered by LF request/command only. Either LF request ...

Purge Control Solenoid Valve (PCSV) Removal
1. Turn the ignition switch OFF and disconnect the battery negative (-) cable. 2. Disconnect the purge control solenoid valve connector (A) ...

Categories

Copyright © www.kifomanual.com 2014-2026