Kia Forte: Overhead Console Lamp Removal
Second generation YD (2014-2018) / Kia Forte TD 2014-2018 Service Manual / Body Electrical System / Lighting System / Overhead Console Lamp Removal
| 1. |
Disconnect the negative (-) battery terminal.
|
| 2. |
Loosen 2 screws holding the overhead console (A).
|
| 3. |
Disconnect the connectors (A) of sunroof switch and lamp switch
then remove the overhead console lamp assembly.
|
| 4. |
If necessary to replace the bulb, replace the bulb after disconnecting
the connectors.
|
Overhead Console Lamp Inspection
1.
Remove the overhead console lamp assembly then check for continuity
between terminals. If the continuity is not as specified, replace the
map lamp switch.
...
Overhead Console Lamp Installation
1.
Install the overhead console lamp after connecting the sunroof
switch connector and lamp connector.
2.
Install the lens after tightening ...
See also:
Start/Stop Button Removal
1.
Disconnect the negative (-) battery terminal.
2.
Using a screwdriver or remover, remove the center garnish [LH]
(A).
...
Emergency Fastening Device (EFD)
Front emergency fastening device operates as well as belt pretensioner
at the same time If it gets into its deploy condition after a collision. It
is located at near anchor on front seat and ...
Flywheel Removal and installation
1.
Remove the manual Transaxle.
(Refer to Manual Transaxle System - "Manual Transaxle ")
2.
Remove the flywheel (A).
...
Copyright © www.kifomanual.com 2014-2024