When heavy rear components such as suspension, fuel tank, spare tire,
tailgate and trunk lid are to be removed, place additional weight in
the luggage area before hoisting. When substantial weight is removed
from the rear of the vehicle, the center of gravity may change and can
cause the vehicle to tip forward on the hoist.
|
|
1. |
Place the lift blocks under the support points as shown in the illustration.
|
2. |
Raise the hoist a few inches (centimeters) and rock the vehicle to be
sure it is firmly supported.
|
3. |
Raise the hoist to full height to inspect the lift points for secure
support.
|
Windshield Wiper-Washer Switch Inspection
Check for continuity between the terminals while operating the wiper and
washer switch. If it is not normal condition, replace wiper and wiper switch.
Wiper Switch
Washer Switch
...
Tire Installation
1.
Apply tire soap or lubrication to the top and bottom tire beads.
2.
To fit the bottom bead, position the valve at the 5 o’clock posit ...
Compression Pressure Inspection
If the there is lack of power, excessive oil consumption or poor
fuel economy, measure the compression pressure.
...