Kia Optima Manuals

Kia Forte: Engine And Transaxle Assembly Installation - Engine And Transaxle Assembly - Engine Mechanical System - Kia Forte TD 2014-2018 Service ManualKia Forte: Engine And Transaxle Assembly Installation

Second generation YD (2014-2018) / Kia Forte TD 2014-2018 Service Manual / Engine Mechanical System / Engine And Transaxle Assembly / Engine And Transaxle Assembly Installation

Installation is in the reverse order of removal.
Perform the following :
•
Adjust shift cable.
•
Adjust throttle cable.
•
Refill engine with engine oil.
•
Refill transaxle with fluid.
•
Refill radiator and reservoir tank with engine coolant.
•
Place heater control knob on "HOT" position.
•
Bleed air from the cooling system.
-
Start engine and let it run until it warms up. (until the radiator fan operates 3 or 4 times.)
-
Turn Off the engine. Check the level in the radiator, add coolant if needed. This will allow trapped air to be removed from the cooling system.
-
Put radiator cap on tightly, then run the engine again and check for leaks.
•
Clean battery posts and cable terminals with sandpaper assemble them, then apply grease to prevent corrosion.
•
Inspect for fuel leakage.
-
After assemble the fuel line, turn on the ignition switch (do not operate the starter) so that the fuel pump runs for approximately two seconds and fuel line pressurizes.
-
Repeat this operation two or three times, then check for fuel leakage at any point in the fuel line.
Engine And Transaxle Assembly Removal
   • Use fender covers to avoid damaging painted surfaces. ...

Timing System
...

See also:

Hood Assembly Replacement
   • Be careful not to damage the hood and body. ...

Front Seat Frame Assembly Replacement
   • Put on gloves to protect your hands. & ...

General Features
• This audio system supports Bluetooth® hands-free and stereo-headset features. - HANDS-FREE feature: Making or receiving calls wirelessly. ...

Categories

Copyright www.kifomanual.com 2014-2026