1. |
Remove the automatic transaxle.
(Refer to Automatic Transaxle System - "Automatic Transaxle")
Remove the manual transaxle.
(Refer to Manual Transaxle System - "Manual Transaxle")
|
2. |
Automatic transaxle : Remove the drive plate.
(Refer to Cylinder Block – “Drive Plate”)
Manual transaxle : Remove the flywheel.
(Refer to Cylinder Block – “Flywheel”)
|
3. |
Remove the rear oil seal (A).
|
Filter replacement
It must be replaced when necessary, and should not be washed.
You can clean the filter when inspecting the air cleaner element.
Clean the filter by using compressed air.
1. Loosen the air c ...
Oil Pump Unit (OPU) Installation
1.
Install in the reverse of removal.
...
Component Location
1. Horn switch
2. Horn relay (Engine room compartment)
3. Clock spring
4. Horn
...