1. |
Measure the primary coil resistance between terminals (+) and
(-).
|
Manifold Absolute Pressure Sensor (MAPS) Inspection
1.
Connect the GDS on the Data Link Connector (DLC).
2.
Measure the output voltage of the MAPS at idle and IG ON.
Conditio ...
Immobilizer Control Unit Removal
1.
Disconnect the negative (-) battery terminal.
2.
Remove the crash pad lower panel.
(Refer to Body - "Crash Pad Lower Panel" ...
Crankshaft Damper Pulley Removal and Installation
1.
Remove the RH front wheel.
2.
Remove the drive belt.
(Refer to Timing System - "Drive Belt")
3.
...