Kia Forte: Fuel Tank Air Filter Removal - Evaporative Emission Control System - Emission Control System - Kia Forte TD 2014-2018 Service ManualKia Forte: Fuel Tank Air Filter Removal

Second generation YD (2014-2018) / Kia Forte TD 2014-2018 Service Manual / Emission Control System / Evaporative Emission Control System / Fuel Tank Air Filter Removal

1.
Turn the ignition switch OFF and disconnect the battery negative (-) cable.
2.
Lift the vehicle.
3.
Disconnect the canister close valve connector (A).
4.
Disconnect the ventilation hose (B).
5.
Remove the fuel tank air filter after removing the mounting bolts (C).

6.
Release the lever (A), and then separate the canister close valve (B) from the fuel tank air filter after rotating it in the direction of the arrow in the figure.

Fuel Filler Cap Description
A ratchet tightening device on the threaded fuel filler cap reduces the chances of incorrect installation, which seals the fuel filler. After the gasket on the fuel filler cap and the filler ...

Fuel Tank Air Filter Installation
   • Install the component with the specified torques. • ...

See also:

Power Mosfet Inspection
1. Turn the ignition switch ON. 2. Manually operate the control switch and measure the voltage of the blower motor. 3. ...

Front Wiper Motor Component Location
1. Cap 2. Nut 3. Wiper arm & blade 4. Retainer 5. Cowl top cover 6. Bolt 7. Wiper motor & linkage assembly ...

General Inspection
After or before servicing the EPS system, perform the troubleshooting and test procedure as follows. Compare the system condition with normal condition in the table below and if abnormal symp ...

Copyright � www.kifomanual.com 2014-2026