Kia Forte: Fuel Filler Cap Description
Second generation YD (2014-2018) / Kia Forte TD 2014-2018 Service Manual / Emission Control System / Evaporative Emission Control System / Fuel Filler Cap Description
A ratchet tightening device on the threaded fuel filler cap reduces the
chances of incorrect installation, which seals the fuel filler. After the gasket
on the fuel filler cap and the filler neck flange contact each other, the ratchet
produces a loud clicking noise indicating the seal has been set.
| 1. Cover 2. Torsion spring 3. Retainer 4. Gasket seal |
5. Spring 6. Plate seal 7. Vacuum valve 8. Spring |
On-board Refueling Vapor Recovery (ORVR) valve Installation
1.
Installation is the reverse of removal.
...
Fuel Tank Air Filter Removal
1.
Turn the ignition switch OFF and disconnect the battery negative
(-) cable.
2.
Lift the vehicle.
3.
Dis ...
See also:
Side Body
* These dimensions indicated in this figure are
actual-measurement dimensions. [ Unit : mm (inch) ]
Front side m ...
TJ Joint Replacement
•
Special grease must be applied to the driveshaft joint.
Do not substitute with another ...
Installation
1.
Install in the reverse order of removal.
2.
After installation, bleed the brake system.
(Refer to Brake system bleeding)
...
Copyright © www.kifomanual.com 2014-2024