Kia Forte: Fuel Tank Air Filter Removal
Second generation YD (2014-2018) / Kia Forte TD 2014-2018 Service Manual / Emission Control System / Evaporative Emission Control System / Fuel Tank Air Filter Removal
| 1. |
Turn the ignition switch OFF and disconnect the battery negative
(-) cable.
|
| 2. |
Lift the vehicle.
|
| 3. |
Disconnect the canister close valve connector (A).
|
| 4. |
Disconnect the ventilation hose (B).
|
| 5. |
Remove the fuel tank air filter after removing the mounting bolts
(C).
|
| 6. |
Release the lever (A), and then separate the canister close valve
(B) from the fuel tank air filter after rotating it in the direction
of the arrow in the figure.
|
Fuel Filler Cap Description
A ratchet tightening device on the threaded fuel filler cap reduces the
chances of incorrect installation, which seals the fuel filler. After the gasket
on the fuel filler cap and the filler ...
Fuel Tank Air Filter Installation
•
Install the component with the specified torques.
•
...
See also:
Components
1. Reverse hose
2. Master cylinder
3. Ignition lock switch
4. Clutch switch
5. Clutch arm assembly
6. Pedal pad
...
Troubleshooting
Vehicle inspection
SYMPTOM CHART
Symptom
Suspect Area
Remedy (See page)
Squeak or grunt-noise from the front suspension,
occurs more in cold ambient t ...
Ambient Temperature Sensor Replacement
1.
Disconnect the negative (-) battery terminal.
2.
Remove the engine room under cover front panel (A).
3.
...
Copyright © www.kifomanual.com 2014-2025