Kia Forte: On-board Refueling Vapor Recovery (ORVR) valve Installation - Evaporative Emission Control System - Emission Control System - Kia Forte TD 2014-2018 Service ManualKia Forte: On-board Refueling Vapor Recovery (ORVR) valve Installation

Second generation YD (2014-2018) / Kia Forte TD 2014-2018 Service Manual / Emission Control System / Evaporative Emission Control System / On-board Refueling Vapor Recovery (ORVR) valve Installation

1.
Installation is the reverse of removal.
On-board Refueling Vapor Recovery (ORVR) valve Removal
1. Turn the ignition switch OFF, and then remove battery (-) cable. 2. Remove the fuel pump. (Refer to Fuel System - "Fuel Pump&qu ...

Fuel Filler Cap Description
A ratchet tightening device on the threaded fuel filler cap reduces the chances of incorrect installation, which seals the fuel filler. After the gasket on the fuel filler cap and the filler ...

See also:

Timing Chain Inspection
Sprockets, Chain Tensioner, Chain Guide, Chain Tensioner Arm 1. Check the CVVT sprocket and crankshaft sprocket for abnormal wear, cracks, or damage. Replace if necessa ...

Inspection
If any of the following conditions occur, WCS reset and accuracy check should be performed. • The WCS ECU or any of the sensors is replaced. • ...

Rear Hub - Carrier Replacement
1. Loosen the wheel nuts slightly. Raise the vehicle, and make sure it is securely supported. 2. Remove the rear wheel and tire (A) from ...

Copyright © www.kifomanual.com 2014-2025