Kia Forte: ETC (Electronic Throttle Control) System Removal

Second generation YD (2014-2018) / Kia Forte TD 2014-2018 Service Manual / Engine Control / Fuel System / Engine Control System / ETC (Electronic Throttle Control) System Removal

1.	Turn the ignition switch OFF and disconnect the battery negative (-) cable.

2.	Remove the resonator and the air intake hose (Refer to “Intake And Exhaust System” in EM group).

3.	Disconnect the ETC module connector (A).

4.	Disconnect the coolant hoses (B).

5.	Remove the installation bolts (C), and then remove the ETC module from the engine.

ETC (Electronic Throttle Control) System Inspection

Throttle Position Sensor (TPS) 1. Connect the GDS on the Data Link Connector (DLC). 2. Start the engine and measure the output voltage of TP ...

ETC (Electronic Throttle Control) System Installation

• Install the component with the specified torques. • ...

See also:

Battery Vehicle parasitic current inspection
1. Turn the all electric devices OFF, and then turn the ignition switch OFF. 2. Close all doors except the engine hood, and then lock all d ...

Components
1. Intake camshaft 2. Exhaust camshaft 3. Intake CVVT assembly 4. Exhaust CVVT assembly 5. Timing chain 6. Timing chain tensioner arm 7. Timing chain tensioner 8. T ...

SS-A Solenoid Valve(ON/OFF) Specifications
ON/OFF Solenoid Valve(SS-A, SS-B) ▷ Control type : Normal low type Control pressure kpa (kgf/cm², psi) 490.33(5.0, 71.12) Internal resistance(Ω ...

Categories

Copyright � www.kifomanual.com 2014-2026