Kia Optima Manuals

Kia Forte: Camshaft Position Sensor (CMPS) Removal - Engine Control System - Engine Control / Fuel System - Kia Forte TD 2014-2018 Service ManualKia Forte: Camshaft Position Sensor (CMPS) Removal

Second generation YD (2014-2018) / Kia Forte TD 2014-2018 Service Manual / Engine Control / Fuel System / Engine Control System / Camshaft Position Sensor (CMPS) Removal

  
•
DON’T remove the camshaft position sensor during engine running or right after engine stops, or a scald by the flowed out engine oil may occur.
[Bank 1 / Intake]
1.
Turn the ignition switch OFF and disconnect the battery negative (-) cable.
2.
Disconnect the camshaft position sensor connector (B) after removing the clip (A).
3.
Remove the installation bolt (C), and then remove the sensor.
[Bank 1 / Exhaust]
1.
Turn the ignition switch OFF and disconnect the battery negative (-) cable.
2.
Disconnect the camshaft position sensor connector (B) after removing the clip (A).
3.
Remove the installation bolt (C), and then remove the sensor.
Camshaft Position Sensor (CMPS) Inspection
1. Check the signal waveform of the CMPS and CKPS using the GDS. Specification: Refer to “Wave Form” ...

Camshaft Position Sensor (CMPS) Installation
   • Install the component with the specified torques. • ...

See also:

Description
Burglar Alarm State [B/A State] B/A State Description DISARM 1. In "DISARM" state, no vehicle start inhibition. So, whe ...

Hands Free Switch Removal
1. Disconnect the negative (-) battery terminal. 2. Remove the driver airbag module. (Refer to Restraint - "Driver Airbag (DAB) Mod ...

BJ Boot Components
1. BJ assembly 2. Circlip 3. BJ boot band 4. BJ boot 5. Dynamic damper band 6. Dynamic damper 7. Shaft 8. TJ boot band 9. TJ boot 10. Spider assembly 1 ...

Categories

Copyright � www.kifomanual.com 2014-2026