Kia Forte: Knock Sensor (KS) Removal
Second generation YD (2014-2018) / Kia Forte TD 2014-2018 Service Manual / Engine Control / Fuel System / Engine Control System / Knock Sensor (KS) Removal
| 1. |
Turn the ignition switch OFF and disconnect the battery negative
(-) cable.
|
| 2. |
Disconnect the knock sensor connector (A).
|
| 3. |
Remove the intake manifold (Refer to “Intake And Exhaust System”
in EM group).
|
| 4. |
Remove the installation bolt (A), and then remove the sensor from
the cylinder block.
|
Knock Sensor (KS) Circuit Diagram
(M/T)
(A/T)
...
Knock Sensor (KS) Installation
•
Install the component with the specified torques.
•
...
See also:
Torque Converter Control Solenoid Valve (T/CON_VFS) Removal
1.
Disconnect the negative (-) battery cable.
2.
Remove the air cleaner assembly and air duct.
(Refer to Engine Mechanical System - &qu ...
Inspection
Front Door Lock Module Inspection
1.
Remove the front door trim.
(Refer to Body - "Front Door Trim")
2.
Remove the front d ...
Brake Switch Inspection
1.
Connect a circuit tester to the connector of stop lamp switch,
and check whether or not there is continuity when the plunger of the
stop lamp switch is pushed in an ...
Categories
- Home
- Kia Forte BD 2019-2026 Owners Manual
- Kia Forte BD 2019-2026 Service Manual
- First Generation
- Second generation
- Kia Forte TD 2014-2018 Owners Manual
- Kia Forte TD 2014-2018 Service Manual
Copyright www.kifomanual.com 2014-2026