1. |
Turn the ignition switch OFF.
|
2. |
Disconnect the HO2S connector.
|
3. |
Measure resistance between the HO2S terminals 2 and 5 [B1/S1].
Measure resistance between the HO2S terminals 3 and 4 [B1/S2].
|
4. |
Check that the resistance is within the specification.
|
Accelerator Position Sensor (APS) Removal
1.
Turn the ignition switch OFF and disconnect the negative (-) battery
cable.
2.
Disconnect the accelerator position sensor connector (A). ...
Multimedia Jack Installation
1.
Install the multimedia jack.
2.
Connect the multimedia jack connector.
3.
Install the floor console assembly ...
Compressor Removal
1.
If the compressor is marginally operable, run the engine at idle
speed, and let the air conditioning work for a few minutes, then shut
the engine off.
...