Kia Forte: Heated Oxygen Sensor (HO2S) Removal
Second generation YD (2014-2018) / Kia Forte TD 2014-2018 Service Manual / Engine Control / Fuel System / Engine Control System / Heated Oxygen Sensor (HO2S) Removal
| [SULEV] |
| 1. |
Turn the ignition switch OFF and disconnect the battery negative
(-) cable.
|
| 2. |
Disconnect the connector (A), and then remove the sensor (B).
[Bank 1 / Sensor 1]
[Bank 1 / Sensor 2]
|
| [LEV2] |
[Bank 1 / Sensor 1]
| 1. |
Turn the ignition switch OFF and disconnect the battery negative
(-) cable.
|
| 2. |
Disconnect the connector (A), and then remove the sensor (B).
|
[Bank 1 / Sensor 2]
| 1. |
Turn the ignition switch OFF and disconnect the battery negative
(-) cable.
|
| 2. |
Remove the console side cover (A).
|
| 3. |
Disconnect the connector (A), and then remove the sensor (B).
|
Heated Oxygen Sensor (HO2S) Inspection
1.
Turn the ignition switch OFF.
2.
Disconnect the HO2S connector.
3.
Measure resistance between the HO2S termi ...
Heated Oxygen Sensor (HO2S) Installation
•
Install the component with the specified torques.
•
...
See also:
Installation
1.
Install in the reverse order of removal.
2.
Compress the piston into the caliper body using the SST(09581-11000).
...
Front Door Inside Handle Replacement
(4Door, 5Door, 2Door)
1.
Remove the front door trim.
(Refer to Front Door - "Front Door Trim")
2.
After loosenin ...
PTC Heater Inspection
Operating Logic Test (Manual only)
Inspect the PTC operation with the confirmation logic below :
1.
Entering
(1)
Set the Floor mode ...
Copyright © www.kifomanual.com 2014-2025