1. |
Turn the ignition switch OFF.
|
2. |
Disconnect the HO2S connector.
|
3. |
Measure resistance between the HO2S terminals 2 and 5 [B1/S1].
Measure resistance between the HO2S terminals 3 and 4 [B1/S2].
|
4. |
Check that the resistance is within the specification.
|
Cowl Side Trim Component Location
1. Cowl side trim
...
Special driving conditions
Hazardous driving conditions
When hazardous driving conditions are encountered such as water, snow, ice, mud,
sand, or similar hazards, follow these suggestions:
Drive cautiously and allow extra ...
Starter Specification
Starter [Non-ISG type]
Item
Specification
Rated voltage
12 V, 1.2 kW
The number of pinion teeth
13
Performance
[No-load, 11 V] ...