Kia Forte: Accelerator Position Sensor (APS) Description

Accelerator Position Sensor (APS) is installed on the accelerator pedal module and detects the rotation angle of the accelerator pedal. The APS is one of the most important sensors in engine control system, so it consists of the two sensors which adapt individual sensor power and ground line. The second sensor monitors the first sensor and its output voltage is half of the first one. If the ratio of the sensor 1 and 2 is out of the range (approximately 1/2), the diagnostic system judges that it is abnormal.

Heated Oxygen Sensor (HO2S) Installation

   • Install the component with the specified torques. • ...

Accelerator Position Sensor (APS) Specification

Accelerator Position Output Voltage (V) APS1 APS2 C.T 0.7 ~ 0.8 0.29 ~ 0.46 W.O.T 3.85 ~ 4.35 1.93 ~ 2.18 ...

See also:

Components
1. Steering column shaft 2. ECU 3. Motor 4. Steering gear box ...

Outside Rear View Mirror Component Location
(4Door, 5Door) 1. Outside rear view mirror (2Door) 1. Outside rear view mirror ...

Mode Control Actuator Inspection
1. Turn the ignition switch OFF. 2. Disconnect the mode control actuator connector. 3. Verify that the mode con ...