Kia Forte: Fuel Tank Pressure Sensor (FTPS) Installation
| •
|
Install the component with the specified torques.
|
| •
|
Note that internal damage may occur when the component
is dropped. In this case, use it after inspecting.
|
|
| •
|
Insert the sensor in the installation hole and be careful
not to damage when installation.
|
|
|
1. |
Install in the reverse order of removal.
|
1.
Turn the ignition switch OFF and disconnect the battery negative
(-) cable.
2.
Remove the rear seat.
(Refer to Body - “Rear Se ...
Based on information from various sensors, the ECM can calculate the fuel
amount to be injected. The fuel injector is a solenoid-operated valve and the
fuel injection amount is controlled by ...
See also:
System operation
Ventilation
1. Set the mode to the
position.
2. Set the air intake control to the outside (fresh) air position.
3. Set the temperature control to the desired position.
4. Set the fan speed ...
Water pump Inspection
1.
Check each part for cracks, damage or wear, and replace the coolant
pump assembly if necessary.
2.
Check the bearing for damage, abnorm ...
Side Impact Sensor (SIS)
Side Impact Sensor (SIS) system consists of two P-SIS which are installed
at each center of the front door module (LH and RH) and two SIS which are installed
at each center pillar nearby (LH ...
Fuel Tank Pressure Sensor (FTPS) Removal
Injector Description