Kia Forte: Injector Description

Based on information from various sensors, the ECM can calculate the fuel amount to be injected. The fuel injector is a solenoid-operated valve and the fuel injection amount is controlled by length of injection time. The ECM controls each injector by grounding the control circuit. When the ECM energizes the injector by grounding the control circuit, the circuit voltage should be low (theoretically 0V) and the fuel is injected. When the ECM de-energizes the injector by opening control circuit, the fuel injector is closed and circuit voltage should momentarily peak.

Fuel Tank Pressure Sensor (FTPS) Installation

   • Install the component with the specified torques. • ...

Injector Specification

Item Specification Coil Resistance (Ω) 13.8 ~ 15.2 [20°C(68°F)] ...

See also:

PTC Heater Inspection
Operating Logic Test (Manual only) Inspect the PTC operation with the confirmation logic below : 1. Entering (1) Set the Floor mode ...

Rear Seat Back Cover Component Location
(4Door, 2Door) 1. Rear seat back cover [LH] 2. Rear seat back cover [RH] (5Door) 1. Rear seat back assembly [LH] 2. Rear seat ...

Side Body
* These dimensions indicated in this figure are actual-measurement dimensions. [ Unit : mm (inch) ] Front side m ...