1. |
Disconnect the negative (-) battery cable.
|
2. |
Remove the air cleaner assembly and air duct.
(Refer to Engine Mechanical System - "Air cleaner")
|
3. |
Remove the under cover (A).
|
4. |
Replace new gasket and the plug after draining the automatic transaxle
fluid by removing the drain plug.
(Refer to Hydraulic System - "Fluid")
|
5. |
Remove the air breather hose (A).
|
6. |
Remove the valve body cover (B).
|
7. |
Remove the plate and the detent spring (A) after removing the
bolt.
|
8. |
Remove the bolt (3ea) after disconnecting the solenoid valve (B)
connector and the oil temperature sensor connector (A).
|
9. |
Remove the valve body assembly (A).
|
Inspection (With GDS)
1.
Check BCM input/output specification of multifunction switch using
the GDS. If the specification is abnormal, replace the lamp or wiper
switch.
...
Fuel Tank Pressure Sensor (FTPS) Circuit Diagram
(M/T)
(A/T)
...
Cruise control system
The cruise control system allows you to program the vehicle to maintain a constant
speed without depressing the accelerator pedal.
This system is designed to function above approximately 25 mph (40 ...