Kia Forte: Injector Installation
| •
|
Install the component with the specified torques.
|
| •
|
Note that internal damage may occur when the component
is dropped. In this case, use it after inspecting.
|
|
| •
|
Apply the engine oil to the injector O-ring.
|
|
| •
|
Inspect the injector O-ring when installing.
|
|
|
1. |
Install in the reverse order of removal.
Delivery pipe installation bolt:
18.6 ~ 23.5 N.m (1.9 ~ 2.4 kgf.m, 13.7 ~ 17.4 lb-ft)
|
|
1.
Turn the ignition switch OFF and disconnect the battery negative
(-) cable.
2.
Release the residual pressure in fuel line (Refer to the ...
Purge Control Solenoid Valve (PCSV) is installed on the intake manifold
and controls the evaporative purge between the canister and the intake manifold.
It is a normally closed solenoid valve ...
See also:
Steering Angle Sensor
The Steering Angle Sensor (SAS) is installed in MDPS (Motor Driven Power
Steering) and it sends messages to HECU through CAN communication line.
The SAS is used to determine turning directio ...
Air Ventilation Seat Unit Description
The ventilated seat system uses a Push method to cool the seat. A blower
mounted in the seat generates the cool air, which then travels through ducts
to the seat back and cushion.
...
Rear Hub - Carrier Components
1. Rear torsion beam axle assembly
2. Rear dust cover
3. Rear wheel hub assembly
4. Rear brake disc
...
Injector Removal
Purge Control Solenoid Valve (PCSV) Description