Kia Forte: CVVT Oil Control Valve (OCV) Installation
| •
|
Install the component with the specified torques.
|
| •
|
Note that internal damage may occur when the component
is dropped. In this case, use it after inspecting.
|
|
| •
|
Apply engine oil to the valve O-ring.
|
|
|
1. |
Install in the reverse order of removal.
CVVT oil control valve installation
bolt:
9.8 ~ 11.8 N.m (1.0 ~ 1.2 kgf.m, 7.2 ~ 8.7 lb-ft)
|
|
1.
Turn the ignition switch OFF and disconnect the battery negative
(-) cable.
2.
Disconnect the CVVT oil control valve connector (A).
...
Variable Intake manifold Solenoid (VIS) valve is installed on the intake
manifold. The VIS valve controls the vacuum modulator which activates a valve
in the intake manifold. The ECM opens or ...
See also:
Steering Gear box Replacement
1.
Loosen the wheel nuts slightly.
Raise the vehicle, and make sure it is securely supported.
2.
Remove the front wheel and tire (A ...
Cylinder Head Removal
Engine removal is not required for this procedure.
•
Use fender covers to avoid damaging ...
Blower Unit Replacement
1.
Disconnect the negative (-) battery terminal.
2.
Remove the heater and blower assembly.
(Refer to Heater - "Heater Unit")
...
CVVT Oil Control Valve (OCV) Removal
Variable Intake Solenoid (VIS) Valve Description