Kia Forte: Variable Intake Solenoid (VIS) Valve Inspection - Engine Control System - Engine Control / Fuel System - Kia Forte TD 2014-2018 Service ManualKia Forte: Variable Intake Solenoid (VIS) Valve Inspection

Second generation YD (2014-2018) / Kia Forte TD 2014-2018 Service Manual / Engine Control / Fuel System / Engine Control System / Variable Intake Solenoid (VIS) Valve Inspection

1.
Turn the ignition switch OFF.
2.
Disconnect the VIS valve connector.
3.
Measure resistance between VIS valve terminals 1 and 2.

Specification: Refer to "Specification"

Variable Intake Solenoid (VIS) Valve Circuit Diagram
(M/T) (A/T) ...

Variable Intake Solenoid (VIS) Valve Removal
1. Turn the ignition switch OFF and disconnect the battery negative (-) cable. 2. Disconnect the variable intake solenoid valve connector ( ...

See also:

Steering wheel
Electric power steering (EPS) Power steering uses the motor to assist you in steering the vehicle. If the engine is off or if the power steering system becomes inoperative, the vehicle may still be ...

26 Brake Control Solenoid Valve(26/B_VFS) Specifications
Direct control VFS[26/B] ▷ Control type : Normal low type Control Pressure kpa (kgf/cm², psi) 9.81 ~ 500.14 (0.1 ~ 5.1, 1.42 ~ 72.54) Current value(mA) ...

Crankshaft Components
1. Crankshaft upper bearing 2. Crankshaft thrust bearing 3. Crankshaft 4. Crankshaft lower bearing 5. Crankshaft position sensor (CKPS) wheel 6. Lower crankcase 7. Gas ...

Copyright www.kifomanual.com 2014-2025