Kia Forte: Temperature Control Actuator Description

The heater unit includes mode control actuator and temperature control actuator.

The temperature control actuator is located at the heater unit. It regulates the temperature by the procedure as follows.

Signal from control unit adjusts the position of the temperature door by operating the temperature switch. Then the temperature will be regulated by the hot/cold air ratio decided by the position of the temperature door.

Evaporator Core Replacement

1. Disconnect the negative (-) battery terminal. 2. Remove the heater and blower assembly. (Refer to Heater -"Heater Unit") ...

Temperature Control Actuator Inspection

1. Turn the ignition switch OFF. 2. Disconnect the temperature control actuator connector. 3. Verify that the t ...

See also:

Fuel Sender Removal
1. Remove the fuel pump. (Refer to Fuel Delivery System - "Fuel Pump") 2. Disconnect the electric pump wiring connector (A) and t ...

Rear Coil Spring Replacement
1. Loosen the wheel nuts slightly. Raise the vehicle, and make sure it is securely supported. 2. Remove the front wheel and tire (A) from f ...

Manifold Absolute Pressure Sensor (MAPS) Description
Manifold Absolute Pressure Sensor (MAPS) is a speed-density type sensor and is installed on the surge tank. It senses absolute pressure of the surge tank and transfers the analog signal propo ...