Kia Optima Manuals

Kia Forte: Variable Intake Solenoid (VIS) Valve Installation - Engine Control System - Engine Control / Fuel System - Kia Forte TD 2014-2018 Service ManualKia Forte: Variable Intake Solenoid (VIS) Valve Installation

Second generation YD (2014-2018) / Kia Forte TD 2014-2018 Service Manual / Engine Control / Fuel System / Engine Control System / Variable Intake Solenoid (VIS) Valve Installation

  
•
Install the component with the specified torques.
•
Note that internal damage may occur when the component is dropped. In this case, use it after inspecting.
  
•
Be careful of foreign material not to flow into the valve.
1.
Install in the reverse order of removal.
Variable intake solenoid valve bracket installtion bolt:
9.8 ~ 11.8 N.m (1.0 ~ 1.2 kgf.m, 7.2 ~ 8.7 lb-ft)
Variable Intake Solenoid (VIS) Valve Removal
1. Turn the ignition switch OFF and disconnect the battery negative (-) cable. 2. Disconnect the variable intake solenoid valve connector ( ...

Canister Close Valve (CCV) Description
Canister Close Valve (CCV) is normally open and is installed on the canister ventilation line. It seals evaporative emission control system by shutting the canister from the atmosphere during ...

See also:

Explanation of scheduled maintenance items
Engine oil and filter The engine oil and filter should be changed at the intervals specified in the maintenance schedule. If the car is being driven in severe conditions, more frequent oil and filt ...

Variable Charge Motion Actuator (VCMA) Description
The Variable Charge Motion Actuator (VCMA) is installed on the inlet of the intake manifold. It consists of a DC motor which actuates the VCM valve and a position sensor which detects th ...

Hazard Lamp Switch Installation
1. Install the hazard switch. 2. Install the center fascia panel. ...

Categories

Copyright www.kifomanual.com 2014-2026