Kia Forte: Canister Close Valve (CCV) Removal
Second generation YD (2014-2018) / Kia Forte TD 2014-2018 Service Manual / Engine Control / Fuel System / Engine Control System / Canister Close Valve (CCV) Removal
| 1. |
Turn the ignition switch OFF and disconnect the battery negative
(-) cable.
|
| 2. |
Lift the vehicle.
|
| 3. |
Disconnect the canister close valve connector (A).
|
| 4. |
Disconnect the ventilation hose (B).
|
| 5. |
Remove the fuel tank air filter after removing the mounting bolts
(C).
|
| 6. |
Release the lever (A), and then separate the canister close valve
(B) from the fuel tank air filter after rotating it in the direction
of the arrow in the figure.
|
Canister Close Valve (CCV) Inspection
1.
Turn the ignition switch OFF.
2.
Disconnect the CCV connector.
3.
Measure resistance between the CCV termina ...
Canister Close Valve (CCV) Installation
•
Install the component with the specified torques.
•
...
See also:
Diagnosis procedure by using diagnostic device
As manual for diagnosis methods by using diagnosis device, the main contents
are as follows:
1.
Connect self-diagnosis connector(16pins) located in the lower
of driv ...
Power Seat Control Switch Inspection
1.
With the power seat switch in each position, make sure that continuity
exists between the terminals below. If continuity is not as specified,
replace the power seat ...
Removal
1.
Disconnect the battery negative cable, and wait for at least three
minutes before beginning work.
2.
Remove the front passenger seat ass ...
Copyright © www.kifomanual.com 2014-2025