Kia Forte: Variable Charge Motion Actuator (VCMA) Inspection
Second generation YD (2014-2018) / Kia Forte TD 2014-2018 Service Manual / Engine Control / Fuel System / Engine Control System / Variable Charge Motion Actuator (VCMA) Inspection
| 1. |
Turn ignition switch OFF.
|
| 2. |
Disconnect the VCMA connector.
|
| 3. |
Check that the VCMA is not stuck by foreign material.
|
| 4. |
Measure resistance between motor (+) and (-) control terminals
of the motor.
|
| 5. |
Check that the resistance is within the specification.
|
| 6. |
Measure resistance between voltage supply terminal and ground
terminal of the position sensor.
|
| 7. |
Check that the resistance is within the specification.
|
Variable Charge Motion Actuator (VCMA) Circuit diagram
(M/T)
(A/T)
...
Variable Charge Motion Actuator (VCMA) Removal
1.
Turn the ignition switch OFF and disconnect the battery negative
(-) cable.
2.
Disconnect the VCMA connector (A).
...
See also:
Variable Charge Motion Actuator (VCMA) Removal
1.
Turn the ignition switch OFF and disconnect the battery negative
(-) cable.
2.
Disconnect the VCMA connector (A).
...
Starter Installation
1.
Install in the reverse order of removal.
Starter installation bolt:
49.0 ~ 63.7 N.m (5.0 ~ 6.5 kgf.m, 36.2 ~ 47.0 lb-ft)
...
PTC Heater Inspection
Operating Logic Test (Manual only)
Inspect the PTC operation with the confirmation logic below :
1.
Entering
(1)
Set the Floor mode ...
Categories
- Home
- Kia Forte BD 2019-2025 Owners Manual
- Kia Forte BD 2019-2025 Service Manual
- First Generation
- Second generation
- Kia Forte TD 2014-2018 Owners Manual
- Kia Forte TD 2014-2018 Service Manual
Copyright www.kifomanual.com 2014-2025