Kia Forte: DC/DC Converter Installation - ISG (Idle Stop & Go) System - Engine Control / Fuel System - Kia Forte TD 2014-2018 Service ManualKia Forte: DC/DC Converter Installation

Second generation YD (2014-2018) / Kia Forte TD 2014-2018 Service Manual / Engine Control / Fuel System / ISG (Idle Stop & Go) System / DC/DC Converter Installation

1.
Install in the reverse order of removal.
  
If the battery negative (-) cable is reconnected after disconnecting, the ISG function does not operates until the system is stabilized for about 4 hours.
DC/DC Converter Removal
1. Disconnect the battery negative (-) cable. 2. Remove the crash pad lower panel. (Refer to Body - Crash pad lower panel.) ...

ISG OFF Switch Description
The ISG OFF switch on the crash pad lower panel can be used to deactivate the ISG function. ...

See also:

Rear Shock Absorber Components
1. Dust cover 2. Shock absorber ...

Output Speed Sensor Signal Waveform
Fig 1) Input/Output speed sensor at low speed Fig 2) Input/Output speed sensor at high speed ...

Front Strut Assembly Replacement
1. Loosen the wheel nuts slightly. Raise the vehicle, and make sure it is securely supported. 2. Remove the front wheel and tire (A ...

Copyright www.kifomanual.com 2014-2025