Kia Forte: Electric Oil Pump Installation - ISG (Idle Stop & Go) System - Engine Control / Fuel System - Kia Forte TD 2014-2018 Service ManualKia Forte: Electric Oil Pump Installation

Second generation YD (2014-2018) / Kia Forte TD 2014-2018 Service Manual / Engine Control / Fuel System / ISG (Idle Stop & Go) System / Electric Oil Pump Installation

1.
Install in the reverse of removal.
Electric Oil Pump Removal
1. Disconnect the negative (-) battery terminal. 2. Disconnect the Electric Oil Pump (EOP) connector (A). 3. ...

Oil Pump Unit (OPU) Connector
Opu Connector Terminal Function E56-A E56-B Pin No. Description Pin No. Description 1 Motor power(W) 1 ...

See also:

Refrigerant Recovery
Use only service equipment that is U.L-listed and is certified to meet the requirements of SAE J2210 to remove HFC-134a(R-134a) from the air conditioning system. ...

Installation
   Clutch cover and disc should be replaced as a set. 1. Apply grease on a disc spline ...

Mode Control Actuator Description
The mode control actuator is located at the heater unit. It adjusts the position of the mode door by operating the mode control actuator based on the signal of the A/C control unit. Pressing ...

Copyright www.kifomanual.com 2014-2026