Kia Forte: Oil Pump Unit (OPU) Removal
Second generation YD (2014-2018) / Kia Forte TD 2014-2018 Service Manual / Engine Control / Fuel System / ISG (Idle Stop & Go) System / Oil Pump Unit (OPU) Removal
| 1. |
Remove the negative (-) battery terminal.
|
| 2. |
Remove the crash pad lower panel.
(Refer to Body - “Crash Pad”)
|
| 3. |
Remove the oil pump unit connector (A) and the DC/DC converter
connector (B).
|
| 4. |
Remove the oil pump unit (C) and DC/DC converter (D).
|
Oil Pump Unit (OPU) Installation
1.
Install in the reverse of removal.
...
See also:
Timing Chain Installation
1.
Check that the TDC marks on the intake and exhaust CVVT sprockets
are slightly turned (about 2 to 3 teeth) from the TDC position after
the timing chain has been rem ...
Cooling Fan Removal and Installation
Cooling fan assembly
1.
Disconnect the battery "-" terminal.
2.
Remove the air duct and air cleaner assembly.
(Refer to ...
Operation Condition for the ISG function
1. Auto stop or Auto start condition
(If all of the below condition are satisfied)
Items
State
Remark
Driving conditions
ISG OFF Switch
...
Copyright © www.kifomanual.com 2014-2025