Kia Forte: Seat Belt Switch Inspection
Second generation YD (2014-2018) / Kia Forte TD 2014-2018 Service Manual / Engine Control / Fuel System / ISG (Idle Stop & Go) System / Seat Belt Switch Inspection
| 1. |
Remove the connector from the switch.
|
| 2. |
Check for continuity between terminals.
|
Seat Belt Switch Description
Via the seat belt/Door switch, the ISG function can detect that the driver
has fastened the seat belt/door. If the driver has not fastened the seat belt/door,
the ISG function reacts as follo ...
Seat Belt Switch Removal
1.
Remove the front seat.
2.
After loosening the mounting bolt, then remove the front seat
belt buckle (A).
...
See also:
Starter Reassembly
1.
Reassemble in the reverse order of disassembly.
...
PTC Heater Inspection
Operating Logic Test (Manual only)
Inspect the PTC operation with the confirmation logic below :
1.
Entering
(1)
Set the Floor mode ...
Tightening Torques
Item
N.m
kgf.m
lb-ft
Ignition coil installation bolt
9.8 ~ 11.8
1.0 ~ 1.2
7.2 ~ 8.7
Spark plug installation
14.7 ~ 24. ...
Copyright © www.kifomanual.com 2014-2025