Kia Forte: Seat Belt Switch Removal

Second generation YD (2014-2018) / Kia Forte TD 2014-2018 Service Manual / Engine Control / Fuel System / ISG (Idle Stop & Go) System / Seat Belt Switch Removal

1.	Remove the front seat.

2.	After loosening the mounting bolt, then remove the front seat belt buckle (A).

Seat Belt Switch Inspection

1. Remove the connector from the switch. 2. Check for continuity between terminals. Seat belt condition Continu ...

Seat Belt Switch Installation

1. Install in the reverse of removal. ...

See also:

Troubleshooting
Problem Possible cause Solution Not pairing Bluetooth device of Car is not discoverable mode Enter Bluetooth pairing (searching) mode User’ ...

Oil Pump Unit (OPU) Installation
1. Install in the reverse of removal. ...

Diagnosis procedure by using diagnostic device
As manual for diagnosis methods by using diagnosis device, the main contents are as follows: 1. Connect self-diagnosis connector(16pins) located in the lower of driv ...

Categories

Copyright © www.kifomanual.com 2014-2025