Kia Forte: Seat Belt Switch Inspection
Second generation YD (2014-2018) / Kia Forte TD 2014-2018 Service Manual / Engine Control / Fuel System / ISG (Idle Stop & Go) System / Seat Belt Switch Inspection
| 1. |
Remove the connector from the switch.
|
| 2. |
Check for continuity between terminals.
|
Seat Belt Switch Description
Via the seat belt/Door switch, the ISG function can detect that the driver
has fastened the seat belt/door. If the driver has not fastened the seat belt/door,
the ISG function reacts as follo ...
Seat Belt Switch Removal
1.
Remove the front seat.
2.
After loosening the mounting bolt, then remove the front seat
belt buckle (A).
...
See also:
Blower Unit Components
1. Intake Seal
2. Intake Upper Case
3. Intake Actuator
4. Air Filter
5. Air Filter Cover
6. Intake Door Assembly
7. Intake Lower Case
8. NVH Pad
9. Blower Up ...
Output Speed Sensor Installation
1.
Install in the reverse order of removal.
After replacement or reinstal ...
Alternator Removal
1.
Disconnect the battery negative (-) cable.
2.
Remove the drive belt.
(Refer to Engine Mechanical System - "Timing Chain")
...
Copyright © www.kifomanual.com 2014-2025