Kia Forte: Removal

Second generation YD (2014-2018) / Kia Forte TD 2014-2018 Service Manual / Clutch System / Clutch Release Cylinder / Removal

1.

Drain the brake fluid through the bleed plug (A).

•	Do not spill brake fluid on the vehicle; it may damage the paint if brake fluid does contact the paint, wash it off immediately with water.

2.

Remove the clutch release cylinder assembly (C) after removing the tube (B) and bolts (A-2ea).

Tightening torque:

14.7 ~ 21.6 N.m (1.5 ~ 2.2 kgf.m,10.8 ~ 15.9 lb-ft)

Inspection

1. Check the clutch release cylinder for fluid leakage. 2. Check the clutch release cylinder boot for damage. ...

Installation

1. Install in the reverse order of removal. Apply the specified grease to ...

See also:

Refrigerant Recovery
Use only service equipment that is U.L-listed and is certified to meet the requirements of SAE J2210 to remove HFC-134a(R-134a) from the air conditioning system. ...

Interior
Interior A * These dimensions indicated in this figure are actual-measurement dimensions. [ Unit : mm (inch) ] Interior B * These dimens ...

Immobilizer Control Unit Removal
1. Disconnect the negative (-) battery terminal. 2. Remove the crash pad lower panel. (Refer to Body - "Crash Pad Lower Panel" ...

Categories

Copyright � www.kifomanual.com 2014-2026