Kia Forte: Installation

Second generation YD (2014-2018) / Kia Forte TD 2014-2018 Service Manual / Clutch System / Clutch Release Fork and Clutch Release Bearing / Installation

1.	Install the boot (A).

2.	Install the clip to the clutch release fork.

3.

Apply to grease in location A, B and C.

Location	Quantity (g)	Remarks
A	0.3 ~ 0.5	Release bearing & Fork
B	0.5 ~ 1.0	Release Fork & Fulcrum
C	0.4 ~ 0.8	Release cylinder & Fork

4.

Apply the grease to the hole surface of the clutch release bearing all around.

Specified grease : CASMOLY L9508

Amount : 0.5 ~ 1.0 g

5.	Install the clutch release fork (B), clutch release bearing (A).

6.	Install the transaxle assembly. (Refer to Manual Transaxle System - " Manual Transaxle")

Inspection

1. Check for damage to boot. 2. Check for deformation to clutch release fork. 3. Check for deformation to clutc ...

Concentric Slave Cylinder Assembly

...

See also:

Relay Box (Passenger Compartment) Removal
Passenger Compartment Junction Box (SJB) 1. Disconnect the negative(-) battery terminal. 2. Remove the crash pad lower panel. (Refer ...

Telemetics Unit (TMU) Component
Connector Pin Specification No. Pin Name Type From To Description (Wiring Spec.) 1 GND DC Ground TMU Batt ...

Glove Box Housing Component Location
1. Glove box housing ...

Categories

Copyright � www.kifomanual.com 2014-2026