Kia Forte: Control Cable Removal
Second generation YD (2014-2018) / Kia Forte TD 2014-2018 Service Manual / Manual Transaxle System / Manual Transaxle Control System / Control Cable Removal
| 1. |
Remove the floor console assembly.
(Refer to Body - " Floor Console")
|
| 2. |
Remove the select cable (B) by removing the snap pin (A).
|
| 3. |
Remove the shift cable (B) after removing the clip (A).
|
| 4. |
Remove the cable socket (A) from lever assembly after pulling
the cable socket clip in the direction of the arrow.
|
| 5. |
Remove the retainer (A) after loosen the nut (B).
|
| 6. |
Remove the air cleaner assembly.
(Refer to Engine Mechanical System - "Air Cleaner")
|
| 7. |
Remove the battery and battery tray.
(Refer to Engine Electrical System - "Battery")
|
| 8. |
Remove the shift & select cable.
|
| 9. |
Remove the shift cable at cabin room.
|
Control Cable Inspection
1.
Check the select cable for proper operation and for damage.
2.
Check the shift cable for proper operation and for damage.
...
Control Cable Installation
•
When installing, set room side Shift lever and T/M side
lever to N position.
...
See also:
Output Speed Sensor Description
The output speed sensor is a vital unit that measures the rate of rotation
of the transaxle's turbine shaft and output shaft, and delivers the readings
to the Transaxle Control Module(TCM ...
General Service Information
Protection Of The Vehicle
Always be sure to cover fenders, seats, and floor areas before starting work.
The support r ...
Drive Belt Installation
1.
Install the drive belt.
(1)
Install the drive belt (C).
(2)
Adjust the tension by t ...
Copyright © www.kifomanual.com 2014-2025