Kia Forte: Battery saver function - Lighting - Features of your vehicle - Kia Forte TD 2014-2018 Owners ManualKia Forte: Battery saver function

Second generation YD (2014-2018) / Kia Forte TD 2014-2018 Owners Manual / Features of your vehicle / Lighting / Battery saver function

If necessary, to keep the lights on when the ignition key is removed, perform the following:

1) Open the driver-side door.

2) Turn the parking lights OFF and ON again using the light switch on the steering column.

Headlight escort function (if equipped)

The headlights (and/or taillights) will remain on for approximately 20 minutes after the ignition key is removed or turned to the ACC or LOCK position.

However, if the driver’s door is opened and closed, the headlights are turned off after 30 seconds.

The headlights can be turned off by pressing the lock button on the transmitter (or smart key) twice or turning off the light switch from the headlight or Auto light position.

CAUTION

If the driver gets out of the vehicle through other doors (except driver's door), the battery saver function does not operate and the headlight escort function does not turn off automatically. Therefore, It causes the battery to be discharged. In this case, make sure to turn off the lamp before getting out of the vehicle.

WARNING

If the headlights are not working properly have your vehicle inspected by an authorized Kia dealer. Don't attempt to inspect or replace the wiring yourself to prevent malfunction.

Lighting
...

Daytime running light 
Daytime Running Lights (DRL) can make it easier for others to see the front of your vehicle during the day. DRL can be helpful in many different driving conditions, and it is especially helpful aft ...

See also:

Parking Brake Cable Adjustment
Parking Brake Lever Stroke Adjustment 1. Remove the floor console. (Refer to Body group - "Floor console") 2. Apply the b ...

Variable Intake Solenoid (VIS) Valve Inspection
1. Turn the ignition switch OFF. 2. Disconnect the VIS valve connector. 3. Measure resistance between VIS valve ...

Installation
1. Remove ignition key from the vehicle. 2. Disconnect the negative (-) cable from battery and wait for at least thirty seconds. ...

Copyright © www.kifomanual.com 2014-2025