A : Wiper speed control (front)
B : Intermittent control wipe time adjustment
C :Wash with brief wipes (front)
D : Rear wiper/washer control
E :Wash with brief wipes (rear)
Windshield wipers
Operates as follows when the ignition switch is turned ON.
MIST :
For a single wiping cycle, push the lever upward and release it. The wipers will operate continuously if the lever is held in this position.
OFF :
Wiper is not in operation
INT :
Wiper operates intermittently at the same wiping intervals. Use this mode in a light rain or mist. To vary the speed setting, turn the speed control knob.
LO :
Normal wiper speed
HI :
Fast wiper speed
If there is a heavy accumulation of snow or ice on the windshield, defrost the windshield for about 10 minutes, or until the snow and/or ice is removed before using the windshield wipers to ensure proper operation.
Power Mosfet Replacement
1.
Disconnect the negative (-) battery terminal.
2.
Disconnect the power mosfet connector (A) and then remove the
power mosfet (B) after lo ...
Intake Air Temperature Sensor (IATS) Circuit Diagram
(M/T)
(A/T)
...
Specifications
Items
Specifications
Rated voltage
DC 12V
Operating temperature range
-30°C ~ +80°C (-22 ~ +176°F)
Rated load
Dimmer & pas ...