Kia Forte: Line Pressure Control Solenoid Valve Removal
Second generation YD (2014-2018) / Kia Forte TD 2014-2018 Service Manual / Automatic Transaxle System / Automatic Transaxle Control System / Line Pressure Control Solenoid Valve Removal
Replacing an on/off solenoid valve (SS-A, SS-B) does not require
additional hydraulic pressure adjustment; however, the hydraulic pressure
will need to be adjusted after replacing the VFS solenoid valve. If
replacing the VFS solenoid valve; also replace the valve body assembly.
(Refer to "Valve Body" in this group)
|
Line Pressure Control Solenoid Valve Inspection
1.
Turn ignition switch OFF.
2.
Disconnect the Solenoid valve connector.
3.
Measure resistance between sensor ...
35R Clutch Control Solenoid Valve(35R/C_VFS) Description
35R Clutch (35R/C) Control Solenoid Valve is attached to the valve body.
This variable force solenoid valve directly controls the hydraulic pressure
inside the 35R clutch.
...
See also:
Component Location
1. Sunroof
2. Sunroof switch
3. Sunroof motor & controller
...
AGM Battery Inspection
Battery Diagnostic Flow
Vehicle parasitic current inspection
1.
Turn all the electric devices OFF, and then turn the ignition
switch OFF.
...
Engine Control Module (ECM) Installation
When replacing the ECM, the vehicle equipped with the immobilizer
must be performed procedure as below.
...
Categories
- Home
- Kia Forte BD 2019-2026 Owners Manual
- Kia Forte BD 2019-2026 Service Manual
- First Generation
- Second generation
- Kia Forte TD 2014-2018 Owners Manual
- Kia Forte TD 2014-2018 Service Manual
Copyright www.kifomanual.com 2014-2026